Ultra Intake Time

P

Ponyfreak

Registered
Well my last modded 1st Gen intake worked so well, that i decided to do it right this time.

On all the intakes I have done, I just ported the intake and the IMRC's, and radiused the runners, and cleaned the inside of the plenum, ect.

This time I decided to do a lot of welding..
Here is what I did today....
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 001.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 002.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 003.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 006.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 007.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 008.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 010.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 013.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 014.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 016.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 017.jpg
http://www.markviii.org/~ponyfreak/ultraintake/ultraintake 018.jpg

What I am going to do is: Shorten the secondary runners bu 1.75", and legthen the primary runners about 1" or so. I will also enlarge the plenum, and move the TB placement. After that I will port/polish everything up to a shiny smooth finish.
 
RE: Ultra Intake Time

Some of the pics I took are for some poeple to know what to do if they dicide to do this, and what tolerences are where, ect... YOu people know who you are. IF you have any ?'s jsut ask.
 
You must log in or register to reply here.
Back
Top