RE: drivers door handle?
Just had mine off, on my '94, probaly same for gen2. Remove lens cover over light on bottom left, remove long screw. On mine, pry up window button switch plate (from pointy end toward dash), in cavity there is a bolt to remove (about 9 or 10mm), push door lock stem down to clear it when removing panel, push up on panel from bottom until loose(should rise about 1 inch or so), while raised, tilt top away from door, remove panel (extra long clasps on bottom to clear). Take loose various wire connectors (some are clips, some are screwed in), peel back thin door cavity cover. You now have access, make your repairs. Reverse everything to button up. When placing panel back, hook the two extra long clasps first, on bottom, then press, while lifting, the panel flush with door. Make sure door lock stem is through hole on top, and all clasps are into their specific door cavity, then push down on panel to engage clasps. replace bolt and screw. Be careful, the clasps are plastic.