Announcement

Collapse
No announcement yet.

Swapping a 98 trans into my 97 Pin Question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Swapping a 98 trans into my 97 Pin Question

    What do I do with the extra power pin. Can I use a harness from a 98 if not can I pull the pins and move them ?
    http://www.sccoa.com/forums/attachme...1&d=1320793147
    Last edited by mag; 09-06-2017, 07:44 PM.

  • #2
    Can I use the MLPS -VSS and TCC on the 98 tranny ?
    Last edited by mag; 09-07-2017, 07:44 AM.

    Comment


    • #3
      Help anyone I have a small window of opportunity to grab this built tranny.It will work with minor modification correct ?
      Last edited by mag; 09-07-2017, 11:27 AM.

      Comment


      • #4
        people have been swapping 98 transmissions into earlier cars for years.
        TCCOA has good articles and posts on the wiring changes needed.
        1996 Lincoln Mark VIII LSC Opal Opalescent on grey, 276/287
        1995 Lincoln Mark VIII LSC Indigo Lights on black
        2002 Ford Focus SVT Sonic Blue on black

        Comment


        • #5
          Yes, you repin the connector and use the 97 MLPS and TCC solenoid.

          Bill
          1994 Deep Jewel Green 183,142 miles
          1997 White LSC 135k miles
          1998 White Collectors Edition 175k
          1994 Black (#2) 100k miles
          1993 Deep Jewel Green Convertible

          Comment


          • #6
            you can delete the extra power pin as it is not needed. I wrapped mine up in electrical tape and inserted it in to the plug.
            re-pinning is done so you can retain your 97 controls/MLPS/TCC, etc
            I used a new TCC solenoid and trimmed the plastic connector down so it would fit under the circuit board.

            buy model-year specific parts (i.e. 97 MLPS, TCC solenoid, etc) and the re-pin takes care of making them work. Your PCM is still the same so the re-wiring allows it to communicate with the circuit board of the new tranny.

            best mod out there is a 98+ trans in to a pre-98.

            while its out, upgrade your converter to a mach 1/Marauder TC.

            keep in mind the angle of the plug you are staring at as you re-pin it...the drawings on TCCOA that is. (from behind, not from the front)
            Last edited by BlackIceLSC; 09-09-2017, 09:19 AM.

            Comment


            • #7
              Originally posted by mag View Post
              Can I use a harness from a 98 ...
              If you have the external harness from a 98 M8, then you can use that to swap the 98 transmission into a 97 Mark VIII without ANY other changes.

              No repining, no splicing, just plug and play. No changes to any wiring (car or trans side). MLPS/TCC/Shift solenoids all have the same values.
              -------------------
              Markless.

              "Do or do not. There is no try" - Yoda

              Comment


              • #8
                http://www.tccoa.com/articles/tranny...n/page16.shtml
                Last edited by tonybrooklyn; 09-21-2017, 08:13 PM.

                Comment

                Working...
                X