Modified Gen 1 wire harness for Cobra intake

Ponyfreak

Registered
I have a Gen 1 wire harness that has been modified to work with 96-98 Cobra intake. Extensive modifications have been done to hide virtually all of the wires underneath the intake for a nice clean look. Wires that have been shortened or extended were all soldered, heat shrinked, and then reloomed.

Harness has been tested and workes perfectly.

$150 obo.
 
RE: Modified Gen 1 wire harness for Cobra intake

Does this have the modification for the Cobra IMRCs controller or will it work with the GEN I's?

I was planning on using the Gen I vacuum controller and rods with the
cobra IMRCs and modifying my harness as you have. If this will save me a lot of headaches, I'm definitely interested.

Also, I think I we owe each other some parts. Give me a call.

Mike McNamee
cell: 404-386-8355
 
RE: Modified Gen 1 wire harness for Cobra intake

Pictures on cardomain site...

Yeah, that's one of them. It uses a Corvette suspension and a mark VIII engine.

I think this one was on ebay and went over $45k, but still didn't meet the reserve.

Mine will be close to that mechanically, but I'm using a modified stock suspension in back and a mustang II susp. in front. I wanted to have TBird wire wheels (although wider) and keep the fender skirts, so I decided to just beef up my stock rear suspension and shorten it to fit.

There is also a 55 or 56 on my site with bucket seats and a center console which I'm using for interior ideas.
 
Back
Top