Hello. I went to the exhaust shop today, a guy that has done my exhaust on every vehicle i own with pipes on. Well, I got the magnaflow X-Pipe resonator combo in one, and 2 bulletts off of summit, dynomax. I went to the exhaust shop today, and he put it up on the lift and we took a look at it, and seems like only the resonator will fit in place of the 3rd cat, and not enough room for the bullets after that, i mean there is room but the brace that crosses over the stock exhaust might be in the way and cause a rattle, especially with 2.5" pipes. What should i do here? He told me he could just remove the factory muffs and put the bullets in the rear, in place of the old muffs. What would be the downside (if any) of putting the bullets in place of the mufflers, instead of having them towards the middle right after the X-pipe/resonator combo? What would be the benefits (if any)? Will there be more drone if the bullets are places in the rear vs the middle? Is there a solution to the brace crossing the stock exhaust and fitment of the bullets? Any advice/comments/suggestions are greatly appreciated!! I'd like to get some input before 11am tomorrow morning because that's when my exhaust appointment is, lol. Thanks very much for any input!!