dnsherrill
Registered
I am doing a hub swap and obtained a pair of rear knuckles with the hub already modded for 4.5''.
Right now I can't figure out how to get one of the torx bolts clear from the bottom of the axle to pull out the knuckle...what am I not seeing or doing?
thanx, Dan
96 Mark base model
---
driver's side shown
Right now I can't figure out how to get one of the torx bolts clear from the bottom of the axle to pull out the knuckle...what am I not seeing or doing?
thanx, Dan
96 Mark base model
---
driver's side shown
Last edited: