How high can you go?

driller

El Presidente
Staff member
How high can you go?

mini-IMG00126-20100116-1602.jpg

:D
 
Nice 4x4!

LOL! :D

I'm hoping 4x4 mode works to make it easier to get the car on the trailer, especially after I put the Mach 1 chin spoiler on. ;)

The Asham8 module needed replaced and I finally got around to it.

Stock Height:
mini-IMG00119-20100116-1552.jpg
mini-IMG00120-20100116-1552.jpg


Cruising Height:
mini-IMG00121-20100116-1554.jpg
mini-IMG00122-20100116-1555.jpg


Slammed Mode:
mini-IMG00123-20100116-1556.jpg
mini-IMG00124-20100116-1556.jpg


4X4 Mode:
mini-IMG00125-20100116-1601.jpg
mini-IMG00126-20100116-1602.jpg

:D
 
My cruising height is about the same as yours...but not adjustable in my case.

At what height do you set it for the strip? Can you set the rear at max height and the front really low?
 
At what height do you set it for the strip? Can you set the rear at max height and the front really low?

I usually have it at cruising height and turn the suspension off after it lowers to curb height so it is not working up and down at the track.

You can tweak the rear height with the ASHAM8 but it is not 'user friendly'. You have to lift the module out and adjust a rotary pot on the bottom of the unit. From lookin at the pics, I might need to measure the suspension height and see if the rear is a smidge high.
 
It's about time you got that thing working!:D

The Module VIII has an adjustment to tweak the front to rear height also. It seems to be a bit nonlinear depending on the height. This may just be the nature of the beast.

I adjust mine at the height that I normally use most often, about an inch and a half lower.

bamodule.jpg
 
I'm not totally sure... but I think so far I win... :D

2117571170039881733S600x600Q85.jpg


2848075890039881733S600x600Q85.jpg


2358271780039881733S600x600Q85.jpg


I wish it had been a little brighter outside...

:D -J
 
Back
Top