Search results

Ive been thinking about a from scratch intake for a while now and since aluminum is pricey and tricky to weld and the right equipment is serious cash. I was wondering about the flux wire mig welders for steel. the oil from the pcv valve if located behind the throttle body might have enough oil...

if someone can post the graph for me send me an email glenh34@excite.com

I finished my short runner intake imrc delete. Test drive today was good. A very slight stumble low rpms that went away thank you reset computer. no check engine light from wheres the imrcs? Midrange seemed to pick up and higher rpms no real noticable loss on low end a punch off the line. I...

very intersted in what the readings are. summer winter higher stall etc.

need for speed is saying that they can achieve 18% more airflow by porting stock imrcs and using different screws that hold the butterflys in place? any comments? check their website.

who has installed a convertor what kind? what stall? how is the regular drivability? and the reason why you bought it vs. some other mod - the foot to the floor effect? your input will be appreciated even if your response is short and to the point.

I ordered the headers I will be installing them myself. Any photos from any angle would be appreciated. I have a camrea and will take plenty of pics. of the install. As long as I am down there is there any advantage installing solid motor mounts ?

I have some dyno results . I am hoping that I can email them to someone and they can post them thanks in advance Glen.