racebronco2
Registered
I picked this up today. Kenne bell 2.1 bower, intake is tapped so that the ecu has a more accurate intake temps. It does comes with idle air control valve re-locator but does not come with aic valve unless i can find one laying around. It comes with several more pulleys than what is shown but he's in the middle of moving and can't find them at the moment. With a stock lower and the pulley that is on the blower he was at about 10psi. It has numerous fitting and hoses i will include!
This kit is not inter-cooled and keeping the temps down with meth would add alot of power. On a warm day when it was tuned the intake temps were over 200* and still it put down 330rwhp. Other people with using meth get close to 400rwhp. I'm really temped to put this on my 98 Mark VIII, than i too will have a
HOT ROD LINCOLN.
I'm asking 2000.00, if no interest in a couple of days it's going on Ebay.
This kit is not inter-cooled and keeping the temps down with meth would add alot of power. On a warm day when it was tuned the intake temps were over 200* and still it put down 330rwhp. Other people with using meth get close to 400rwhp. I'm really temped to put this on my 98 Mark VIII, than i too will have a
HOT ROD LINCOLN.
I'm asking 2000.00, if no interest in a couple of days it's going on Ebay.
Last edited: