Pulley install
- Thread starter driller
- Start date
Greenemachine
Registered
RE: Pulley install
i have no answer for you however I kinda had a question about pulling that pulley. how is it done? i know how to get the bolt off I just never used one of those pullers. theres 3 bolts so you screw it into there and then what?
i have no answer for you however I kinda had a question about pulling that pulley. how is it done? i know how to get the bolt off I just never used one of those pullers. theres 3 bolts so you screw it into there and then what?
RE: Pulley install
[div class="dcquote"][strong]Quote[/strong]
i have no answer for you however I kinda had a question about pulling that pulley. how is it done? i know how to get the bolt off I just never used one of those pullers. theres 3 bolts so you screw it into there and then what?
[/div]
There's a "Y" piece where the bolts go thru slots and into the pulley. Then a long threaded hardened bolt with goes through the center of the "Y" which is threaded. The end of the bolt pushes against the crank and the "Y" piece is then pushed away from the crank, pulling the pulley with it.
[div class="dcquote"][strong]Quote[/strong]
i have no answer for you however I kinda had a question about pulling that pulley. how is it done? i know how to get the bolt off I just never used one of those pullers. theres 3 bolts so you screw it into there and then what?
[/div]
There's a "Y" piece where the bolts go thru slots and into the pulley. Then a long threaded hardened bolt with goes through the center of the "Y" which is threaded. The end of the bolt pushes against the crank and the "Y" piece is then pushed away from the crank, pulling the pulley with it.