Search results

I had an issue like that once. It turned out it was a coil pack that was arcing when under the hood was cold and had moisture in surfaces and in the air. Once the car warmed up and dried out a bit it didn't arc anymore and ran smooth. In rain it was even worse!

Years back I had that happen to my 95 years ago. I just took out the back seat and did a quick repair. I just got some 6 inch wide and 1/8 or 1/4 aluminum stock (can't remember) and cut it about a foot long, then put it over the crack, drilled some holes just slightly undersized for the bolts to...

yep, I know that car on the left

I need to brew more beer, the kegs are dangerously low!

Says Middleboro in his profile location. That is right down the street from me Joe.

I've used it at work before to evaluate pressure between a heatsink and a number of mosfets. Pretty handy stuff. There are various ranges and sensitivities.

Thats one of the major reasons why I just bought the ford extended premium service plan for 8 years and 100k on my MKX. I already had the PTU replaced once under warranty as well as some other work done.

Here is some info on it http://jonathanlackman.com/blog/ford-edge-pdu-pto-transfer-case-issues-flex-500-mkx/

What issue are you having with it? My MKX had a shaft seal leak. The dealership (warranty) ended up replacing the shaft as well as the PTU, just replacing the seal didn't seem to do it. If you are putting a new one in you might want to add a drain plug so you can drain and fill once and a...

My 94 parts car had a manual dimming mirror also. I might still have it kicking around somewhere...

Any roof top cake throwing this year?

Yea thats my favorite part of it. It gives it such a clean profile.

Nice! What did your times and trap speeds look like?

It isn't easy to do without lowering the subframe a bit. I have done but, but I'm still not sure how after looking at how tight it is in there. I did it on another mark, and lowering the subframe a few inches while using an engine brace to keep the engine in place is a hell of a lot easier.

I've heard from Joe, he has been crazy busy with a new job. I'm pretty sure he is going. He was talking about it when I saw him last week. He was asking if I wanted to go (I do!), although as usual timing is just bad for me.

It's amazing what regular maintenance will do!

I can't wait to see it. You are crazy but that's awesome.

Very nice, DLF style!

The first one doesn't look bad at all, especially on a light interior. I really like the second one. The hyrdo dipped stuff can really come out good as long as the print and operator are really good.

Yea it should be legal. As far as I know (and I have looked) there isn't a height requirement in MA. The law says front plate must be displayed. EDIT** This is the only reference in Mass law https://malegislature.gov/Laws/GeneralLaws/PartI/TitleXIV/Chapter90/Section6 "one number plate to be...