Cobra intake manifold bolt orentation HELP

ROCKER

Registered
So can someone tell me the bolt orientation so I can install the cobra intake I just purchased .
 
I purchased an intake manifold that was disassembled along with a bag of hardware.
I need to know which bolt goes into what hole. and the torque sequence.
 
I remember vaguely when I installed the 96-98 Cobra manifold on my 96 Mark VIII the bolt torque and sequence was the same as the stock intake. Basically there are two "inside" bolts near the center, two outside bolts each side and each end for ten bolts total. You started with the center two, then work outwards in an "X" pattern to the ends. Here's the stock torque sequence:

Screen Shot 2022-03-04 at 10.59.02 PM.png

That's the best I've got... hope it helps. ;)
 
Or did your "bag of bolts" come with some of different lengths? I've never had one of these manifolds off, but I can imagine how nervous I'd be if I was provided with two "suspiciously long" bolts, for example...
 
Back
Top