Search results

I need the 3 height sensors and 4 solenoids, i'm redoing my air suspension. Might even need the relay for the air suspension if thats bad, but i know for a fact i'll need the height sensors. Might get a solenoid or 2 with the bags but it'd never hurt to have some backups to reseal. I'm located...

Bent a rim, and the only rims i can find locally would cost me more on tires than i spent on the lincoln. Post up in the thread or text me at 561-313-2911. I will post a picture of the ones i'm using now if you have a single one, but if you have a set feel free to hit me up too. 96 lincoln mark...

I've had my x2 unlocked about a month but haven't found anyone local who can make me a tune, my car is 100% stock other than an adjustable FPR and bigger fuel pump. I just want a base tune to play with, something to get rid of the tip in retarding of the timing, and the retarding during shifts...

I popped my hood to verify that in the morning there is 0 fuel pressure, when i notice a very very slight noise. I put my ear over the schrader valve and while it is completely empty of fuel, i can hear a noise coming from it, a leaking sound. I pressurize the rail and the noise stops. My fuel...

Are all of them like this with the actron scanners on the bottom? I looked it up on the manual and that shows it means the cali standards, not just federal standards, which i assume are stricter being cali. Could that be why i can't get the best fuel mileage out of my mark, and the computer is...

Been calling around, my first mark viii I could find it all day for 200-250 including fluid, now everyones asking for 350-400. Best price I found to swap the tranny and tc was 330 including fluid, book time shows 5 hours. One shop actually had the balls to tell me they had to drop the subframe...

Looking for a much better torque converter, might get some higher gears too. Let me know what you have or can get, i'm interested in 3000-3500 stall TCs.

I have 2, my softer nicer looking one has a lot of holes in the side when closely inspected, and the one i have been using is hard from the heat. Going to use vaseline then clean it off and glue to the intake tube. Any suggestions would be helpful, as i dont know what else would recondition it...

Made a new thread because my old one's title was kind of misleading. I still believe i have a vacuum leak, just because of never having one in this car and with how rough we have been with some of the jobs lol. But my main problem is a high load % at idle. I believe 60% with a/c, 50% without...

I just changed the fuel pump, thinking it was a lack of fuel causing the high ignition timing. Definitely needed the pump at 141k. Pulls much harder at high rpms. Car has had upper and lower intake gaskets done already, i changed the pcv valve, no obvious leaks that spraying brake cleaner on the...

I tried to use my defroster earlier, and it was blowing hot, so i tried to turn it down and my cold air would not come back after, nor work for defrosting. Still can't get cold air. I was thinking my blend door, then i looked under my hood and my compressor clutch is spinning, but my liquid line...

I'm not sure where to post this, but move this if it is in the wrong spot, I was going to get oem replacement spectra radiator since mine has an ugly leak. I was googling to see what i could get if i spent more on an all aluminum, and i found the same radiator they sell for 133 at rock auto for...

My old car i know it would not be possible to unbolt it and change it with a good one, but on this car, would it be possible to unbolt the drivers rear quarterpanel so i don't have to paint my whole car to fix the bondo spot? I've had it bondoed forever, because i was planning on having it all...

Can't find any vacuum leaks with spray, looked around for any loose or broken vacuum lines. Not sure if i should change my dpfe sensor since its original or not. I changed the egr gasket, thats all when i was back there. The code is for high pressure and i don't believe that a broken or...

Before i check the out to figure out why i get a P1537, trying to make sure i can find one somewhere. I haven't seen any 96s in the junkyard recently.