Opal97MarkVIII
Registered
When I bought my car, the drivers side headlight seemed to leak anytime it rained, and then get foggy for a while until the water dried up. So last week I called Max and ordered a new headlight. I went to install the new headlight assembly, and the wires for the low beam have a different connector than the factory connector. On top of this, I can't seem to get the factory connector to come apart. From reading the service manual, I am getting the feeling that they want you to replace the ballast when you replace one of the headlamps. I just can't see why you would have to replace the ballast. Anyone ever run into this same problem? Do I need to call Max and have him send me a different connector or what? I did notice that the part numbers are slightly different on the new and old headlamp assembly. The new one has a "C" at the end, and the old one has an "A" at the end.
Any help would be greatly appreciated.
Thanks in advance,
Any help would be greatly appreciated.
Thanks in advance,