Maybe

Stone17

Registered
I'm thinking about selling my 94 Mark VIII with 189k miles.
Its going to cost way to much money to get it running right.

Goodies on the Mark VIII
4.10 Gears
MMX Driveshaft
HIDs
Aftermarket Radio, AMP and Sub with amp

How much do you think I can get for the Car?

Engine leaks oil.
 
Not much. :) Especially without pictures. What does it need to "run right"? The oil filter adapter gasket is only a couple bucks. Maaaaybe...you could stop spending money on that CTS and fix up a car that has been good to you!
 
Not much. :) Especially without pictures. What does it need to "run right"? The oil filter adapter gasket is only a couple bucks. Maaaaybe...you could stop spending money on that CTS and fix up a car that has been good to you!

I had the oil pan gasket and filter adapter gasket replaced. It look like the rear main seal is leaking.
 
Last edited:
What does it need to "run right"?

The front suspension and brakes just piss me off the most.
Brakes are soft (I know bleed the brakes).
I replace every front suspension on the car and I still hate it.
Steering wheels feels loose. Like the power steering pump is working full power and make the car hard to drive.

And the HID light is pissing me off too.
How do you align the gawd dang headlights?
My headlights looks like a retard set it up.
 
Maaaaybe...you could stop spending money on that CTS (I got a "V" Stone17)!

HAHA.
In the summer I'm going to replace the flywheel and clutch.
I really want new half shafts and rear diff. Carbon Fiber driveshaft would be nice too.
 
Hey, even better! :D

J,

I see that your are a
board-of-directors-plate-sandpaper125.gif
. Lets get a CTS-V section going.
 
Already have it, but you have to own a running Mark Viii to be able to post in it. :p
 
to adjust the headlights you need a 4mm socket or wrench, open the headlight covers, find the little pin sticking out and adjust headlights. super easy.
 
If the front suspension is aligned and fit but still not to your liking, the steering joint can be replaced with a Flaming River u-joint along with a full set of front suspension braces.

That will make the car drive like it was on rails. ;)
 
to adjust the headlights you need a 4mm socket or wrench, open the headlight covers, find the little pin sticking out and adjust headlights. super easy.

The pin is all stripped out and the clip does not lock the pin in place.
So all the pin does is spin.
 
Back
Top