Rear Neon

[mymark93]

I just bought an inverter from Glitch and have a couple of questions about the install.
1. Is it okay to drill out the rivets that hold the back plate on or will that hurt something? Is there another way to remove these rivets?

2. Also do you have to rivet the back plate back on? I don't own a rivet gun and was wondering if I need to go buy one.

3. It says to measure the GTO leads, can anyone be more specific on which ones these are? Also what is the purpose of measuring them, do they have to be replaced?

 

[whiplash15]

Yes, drill out the rivets. No, you do not need to rivet it back on. Sorry, I cant answer your last question.

 

[Marked_Man]

The GTO wires are the thickest wires,the white ones on the replacement ballast and the White wire and the blue wire leading into the ends of the housing. You measure them because there's inline plugs that connects the ballast to the neon. I didn't do that part because my gto wires were pretty worn out along the housing.

 

[mymark93]

Thanks. So, do you put the housing back on at all?