I replaced both front hubs and bearings on my Mark.....pretty straight forward except when I torqued the retaining nuts.....my torque wrench only goes to 150 ft/lbs. Now I know the torque goes to over 200 ft/lbs but I can't get there....so do I worry about NOT having the "proper" torque on the retaining nuts?.....the 1st time I did this I put the 150 ft/lbs on and then cranked a little more......how much more?......only God knows.....let's just say those nuts were on very,very tight.....especially the LT one.....I don't want to do that again!......so is 150 ft/lbs OK?