Search results

Isent you a email and a PM from another board.

Wow, you run the heck outta the car. I am in the same direction as you as far as mods. I have a center section I am going to put 4:10's and a posi in, I need to get driveshaft also mine is 2 piece, so may take a little while to get everything done. Hopefully ready for opening of race season...

I have a question, well a few. I have a 94, has a Diablo chip which firmed up the shifts, mostly the 1-2. I am thinking of a shift kit or Jmod. Is one better than the other?? Will either be too much with the chip?? Shift too harsh??? What stages or settings are good??? I dont want it too...

I am getting ready to align my car and was wondering what Height I should use when performing the alignment??? What I mean is should I use the lowered height like when you turn your car off and get out the car lowers, or the height as when you start your car and it raises then turn off the...

I removed the pass. side Cat. completely, the drivers side I gutted since it is part of the manifold. Warning-it is really loud and has alot of drone if you just use the center mufler and no cats. I have 2 1/2 inch pipes which is what most people use.

I did the center muffler with the x built in, I have no cats and booooooooy was it too loud, so I added the rear magnaflow mufflers in and no has subtle sound, much better!!! But again I have no cats, with cats would probably be nice. The actual tone with the center muffler is great, does not...

Last night my Mark VIII would not idle below 1400 in park ar 1100 in gear. Today I decide to check it out. Search for vacuum leaks, no leaks found. Ok, let me take off the IAC motor and replace. There are 2 diff ones for my year and was told I have to take it off and give the part number. For...

There is a 95 LSC red by my house that has been there over a month in the same spot and has not moved. Sunroof has been tilted up the entire time and the car has a flat, now the suspension is starting to go down with the cooler weather. Makes me wonder if the car is stolen. It has Mass. plates...

HARD TO FIND ON THEIR SITE BUT THEY GOT EM http://shop.ivalueinternet.com/bigexhaust/index.cfm/action/productdetail/product_id/1344.htm

www.bigexhaust.com has x-pipe

Cut that tab down that was in the way before installing, makes it easier not having to wiggle around the EGR tube!!!!

Where are you located??? I do exhaust on alot of Lincolns. If you are by me I can help out!!

FEW INTERIOR PIECES I NEED 1) trim around dome light switches 2) trim around pass side interior door handle 3) left side cruise control switch cover on steering wheel 4) trim around pass seat belt that goes through r/rear quarter panel cover 5) r/rear ashtray I think thats it, in black

Just wondering how involved it is to replace r/rear axle seal in diff???? From what I could see it looks like unbolt lower control arm and swing assembly outward to remove axle??? Also is axle just snap fit into diff kind of like front wheel drive axles?? Anything commonly wrong that causes this...

SOLD!!!! Thanks for the inquiries!!!!!!

It is suppose to be sold on Sat, 4/10, I am suppose to install it in a guys car, But I dont count it sold till money in hand, I will keep ya posted

I have a Borla rear exhaust for sale. It was originally a cat back for Mark VIII, but since I went true duals I just used the Borla part where it went into 2 just ahead of the rear end, so pipes from there to mufflers and mufflers are whats there in Stainless of coarse. They are in New York...

I dont have them on the car yet, I do not have rims yet either. I was wondering if this size would be ok since I got the tires for free. If not I will have to sell them and get a diff. size!!!

I got a set of Bridgestone Potenza S03 tires in size 225/45-17 and was wondering if they will look too low profile on my 94 Mark VIII. Anyone have this size, and if so pictures please. I have my car at the lowest ride height setting also. Thanks, Nick

I have a 94 Mark VIII with the JBL system, I want to install a Pioneer radio/cd player. What installation wires sets have any of you used with a aftermarket radio. The ones I see have 2 or 3 connectors, when I took my radio out there is a flat connector(8 wires or so), a square 8 wire connector...