Search results

I was talking about fronts. The rears do require the different brackets, though.

Hey guys, so ive been busy as usual. Cleaned out the clutter in my basement, and finally built what ive been wanting for a while. A reloading bench. I reload mainly .45 ACP for my 1911. Here ya go!

300hp COBRA mustang motor... :thumbsup:

All the rubber components could be at risk. The engine itself will run fine on it. Flex fuel vehicles just have a different type of rubber compound that will resist deterioration, due to the ethanol.

Rather than hijack my friend BeerDogs thread, I guess I'll start a new one. I have to replace my vent solenoid, and my tray is half rusted away. I'm going to need a new one lol. It must be in decent shape, so I can sandblast an powder coat! Thanks!

I'm also looking for one that's not rotted out. Pm me or reply!

You can get the rings from the wheel manufacturer. Also, is your steering wheel vibrating at higher speeds? Check the tires for "hop", or the run out on the tire. Ive seen many of tires be bad and cause issues. Or you can try a rotation, and see if it helps!

You avoided the water box right? Try some better tires. Hooking up right off the line is the key to a great run! Even a 12 second car not getting traction will run a 16 second time. What was the tmp, humidity and elevation of the track?

Do you mean the ding it makes when the key is in the ignition? Edit: just saw ou said info center. Does any warning message pop up when it does that?

Take it back to the shop, tell them ever since you got it back, this has been happening :)

Mine did the same thing. I dont know why, but it corrected itself eventually lol

Damn, just realized you were pretty far away!!! :frown:

I also havent been on much.. where'd J go? lol

Hello peoples! Havent been on much recently, bought the woman her first motorcycle, and been working on my own! I have not been driving the mark VIII recently, the discharge line on the AC is rusted out, and its been hot so Ive been driving the 30mpg in town ZX2 :D I have been contemplating...

Still have the doors? Heated seats? Neon? Ballast? LMK! :D

Check out wire "1002" top left hand side. This runs off of fuse 4, powering everything you've said. I bet this Black/Pink wire is hitting a ground wire or metal somewhere.

Sorry to revive an old thread, but J, what happened? Did you ever get it fixxed? I just pulled a P0446, and I ran the EVAP self test with my scanner and its passing! Vent solenoid?

you're gonna break the blend door arm :)

Just a little FYI, the Orifice tube is what changes the High Pressure, High Heat gas, into a Low Pressure, Cold fluid and its a very important part of the A/C system. Another good thing to check for bad A/C performance is condensors clogging up on the outside. Usually they sit right in front...

Do you have a coil spring suspension? If you do, you can use Tbird upper control arms and save even more money. If youre still bagged, you have to get the mark viii specific control arm, since it has the attachment for the ride height sensor. It's just as easy with as the other side you did!