Search results

Run Well!

Why not drop in an engine from a new Mustang?

sold

connector is round

FOR SALE: Good HID bulb for 96,97 or 98. Wires and connector in tact ready to plug and play. Comes with the plastic cover also. Make me a reasonable offer.

The mechanic did the master cylinder job but there is air in the system and he can't bleed the brakes. Everyone is telling him that there is a special "scan tool" that actuates the the bleeders and it's a dealer job. Is this true?

Where on earth do I get a master cylinder reservoir? 1996 LSC

Music to the ears.

The CBR is 0 to 60 in 2.9 sec were you in a dream state?

Why did this thread just end here?

I need to have him look again. It seems difficult to tell where it's coming from.

1996 LSC . I have an oil leak somewhere. My mechanic thinks it might be a cam shaft seal. Is that a monster job? Or....Does the leak sealer additive solve the problem?:frown-blue:

That is about what the one I found looks like. And even with that tool those trunk clips are a challenge to remove. In the 1996 LSC the 6 bulbs that light the tail light are #168 the 2 back up light bulbs are #3156. Job done Thanks guys.

Thanks guys I'll check Harbor F for the magic tool. Some how I have a feeling that these clips do not go back in very well after extraction.

I went to check the bulbs and I can't remove the felt liner in the trunk . It is held in place with small black buttons and they must require some special tool to extract them. What is the trick? Help, this is stupid.

Thank you This is just 1 of the 4 sections so I'm hoping it's a bulb

I tried the search and had no luck so here ya go. 1996 LSC the first section of tail lights on the left side of the trunk portion of the array is out. Is this a bulb or some LED array with a ballast etc. Thanks for the help.

I wonder if Gen 2 seats into a Gen 1 are plug and play or do you need some wiring mods????

I have a 96 LSC and the front seat skins are bad. I have located some good Gen 2 skins. Can I swap skins?

PM sent.