Recent content by cruisincapri80

Let me know what you need have one spare hid housing and good bulb car has halogens in it also two spare pass door handles a brand new arnott compressor and dryer not installed and a spare grille with a knick that could be repaired all parts for sale. Make a reasonable offer on anything and i'll...

So i'm gonna order parts tonight and I was wondering if any one had any advice or suggestions for suppliers. Looking at ordering ring and pinion and a rebuild kit with trak-lok kit from Super Coupe Performance. Rear carriers bushings and a fuel pump from lincoln motorsports A metal matrix...

There is no carrier bearing the two pieces is actually two tubes slipped inside of each other and welded on the end that connects to the pumpkin. A one piece 93 driveshaft will swap directly in place of it. Many people do this as a substitution for buying the 450 dollar mmx driveshaft. only fun...

So whats the procedure for bleeding the brakes? Had a rotor split in half and the piston pushed all the wal out ruining the seal got air out of that side by pumping and opening the bleeder but the pedal still fades to the floor and doesn't hold pressure at all... On the first pump it goes...

So, apparently i need to tear into the rear end in my car wondering what parts are worth buyin and installing at this point and what are a waste of time and money. Will be ordering 4.10's a driveshaft and some sort of locker when my other car comes back from the shop. I want to do this and be...

So today I go up north where I keep my projects and a bunch of other junk… I open the gate and pull in look to my left where my slightly rusty 91 mustang “project beater” sits that I have been accumulating parts for some time for. Instantly my jaw drops in astonishment I didn’t even recognize...

Alright I've changed the heater core but the retard that helped me had a bright idea. he attempted to cut the heat duct in half. I got it all sealed back up and everything works except it doesn't seem to change all the way to 90 degrees. I changed the thermostat anf both lines going into the...

Well i think its time for a new transmission. looking at a 2000 mustang trans with about twenty thousand on it for 500 i found. Wondering what to look out for and what exactly will need to be changed modified swapped to make it work in my 96 m8. I will do the swap myself and will probably order...

well after learning a valuable lesson about thermostats i finallly got around to pulling hte scrap atant thermo out of my car and putting in a motocraft also changed the electric fan motor and with the ac off the car seems to run right in the middle or a little above the middle of the stock temp...