Search results

I think I have finally found the freon leak..the com,pressor. Was wondering where people have found the best deal on compressors for a '97?? Also..my low side schrader valve is leaking. It appears like I can't replace this valve ( unbelievable ). So has anyone replaced this line because of a...

I went with a 2 in 2 out 2 1/4" Magnaflow muffler with built in X. I installed the muffler in place of the third cat/resonator setup. I then ran dual mandrel bent tubing out to the stock exit locations. I used no other muffler. The sound is awesome. It is exactly what I wanted. There is no drone...

I put Cobra rear shocks on the other day and am real happy with them. The install was easy. Just drop the mount, push out the rubber bushing and bolt in the Cobra shocks. My car ( 96K miles) has ( had )good bushings, many speak of them ripping. Anyway, it was a good mod, one I suggest to anyone...

I wasn't sure my wheel/tire combo would clear, but it does. These are 17 X 9 and 255/45 Tell me what you think...:) http://forums.tccoa.com/showthread.php?s=&threadid=53985

I test fit my 17 X 9 Cobra Rs today. I have 255/45 tires on them. It appears I am going to have an interference problem at the upper part of the spindle. It seems I may need a 1/4" spacer to aleviate this problem. Is this normal? What are you guys doing? This is on my 97 Mark VIII.

selling on ebay for $130-150 for all 4 ??? Was wondering if they held up over time??

need mirror for 97/98 Mark VIII. Could get away with only the glass if you have a cracked bezel. Either way, need one bad and fast :o)

is getting a low coolnt message common even when the coolant is not low? Also, any ideas on a check engine light code saying insufficient EGR flow? I removed the EGR and it was clean and the diaphragm is good, it operates well.

just got this 97 Mark VIIII. I have no drivers seat power function; pasenger is fine. I looked to the power distribution box in engine compartment and checked a 30 A use, which is fine. I can't believe every power motor on this seat has burned up, somehow I believe I am not getting power to the...

does the same posi differential from a solid axle 8.8 fit the independent rear of the Mark VIII?

OK, so can anyone make an accurate list of parts needed ( mods too ) to install a 96-98 Cobra intake maniofld on a 97 Mark??

I am far from a newbie in the automotive field, but the 4.6 is totally new to me. I know that when you run a 3.73 gears, you need a speedo driven gear that is 3 times the drive gear. if you have a 7 tooth T5 drive gear, a 21 tooth driven gear is correct. Now an AOD usually has an 8 tooth drive...