Search results

Eh, after looking a bit at the car today I notice the driver side mount is broken because the engine will lean to the passenger side when I rev the engine even under a little load. What are some good mounts? Going to be spraying out-the-hole with a high stall so I imagine it needs to be a...

Well, I feel like a bit of an idiot. I did not know I had to buy a tuner or a "license" to tune the car. I called a few dyno shops locally here around orlando, and after some research iv'e learned ill need to buy a tuner or at the very least a "license" to get it tuned / dyno'd. So my question...

Well, after finally getting all my research done for the re-pin, ect. I removed my transmission, pull the "2000 mustang gt" transmission and pull all the tarps off of it from storage. At this point I'm newly educated about the 4R70W and proceed to repin my existing harness. Well, I go to plug it...

I've read the different threads on how to do this, and I just want to be clear on a few things. Here's the intake I bought http://www.ebay.com/itm/231859315143 I want to know what else is needed. I assume a fuel rail / injectors? Will mine work if I want to keep it? Also, the EGR will be...

I am absolutely ready to put this 2000 mustang gt (15k miles rebuilt) transmission in the mark. I've been waiting because I want SOME kind of stall on her. So, im ordering these parts tomorrow Green Top...

Iv'e read some articles and watches some videos of "already made" Mark 9's, and a few videos. But apparently a few were made and... who owns it? Where is it parked? And also, is there any evidence of a new Mark 9 hitting in 2016/2017 ? I drive my dream car, the Mark VIII, you couldn't give me a...

Found a 1/98 at a salvage yard in pretty damn good condition, looks very well taken care of, the salvage yard is willing to sell me the engine/trans together for $400. I think this is a bargain and would like to start building me something serious (while its out in the open) to EVENTUALLY throw...

I know our fans are controlled by a mini vfd unless the a/c is on and calling for cooling, but I'd like to make the fan run at all times - can this be done? I know I can wire high voltage to it through a relay with control voltage, but will it hurt the controller to "intercept" the wire from the...

I change my oil religiously, and since I had the car it had a slight tapping noise coming from the engine area, iv'e pinned it down to the front of the motor. Sounds like a timing chain tensioner. It quiets as you rev the engine anywhere over about 2k rpms and sounds normal. After browsing...

http://ocala.craigslist.org/pts/5369285895.html Going to pick it up tomorrow, looks a little oily, but its a 2000 and he claims it only has 17k miles on it. Just want to make sure this bad boy will fit properly, right? Oh and btw Merry Christmas all! It's going to be a hell of a year!

Ok so in some previous posts I mentioned a transmission changeout.. again. XD - so anyway you might have seen my "damn neon light" post in the electrical section, I finally got that sorted and now moving on to my next project, the transmission. I'll be making a cash purchase on this beast on...

http://orlando.craigslist.org/cto/5338133646.html I don't think I've ever seen a trunk like this, it's quite interesting.

Well, first I want to say thank you very much to Steve who provided a ballast for my neon light on my 97. But the DAMN BULB IS NO GOOD !! I have no continuity on the bulb and after double, then triple checking my wiring, I've determined the bulb is no good. I have all the proper voltage incoming...

I've been wanting to peel apart the third light to install some strip LED's in there but taking apart the third light seems impossible, it seems glued. So, considering drilling a hole and sliding in my lights, not a problem, except the fact I think it will slide around a lot and it wont look...

Will this bad boy fit? And is it worth putting in with 170k on it? I didn't check the measurements to see if it fits yet, just wanted your opinions..

Hello, if you didn't read my introduction post awhile back let me just say I've been on these forums for years and now I'm an actual "Member" (YAY!). Anyway, I would like to give you all an idea of the mods I would like to install on my car vs. what I want it to do vs. reality. So...

Well here's a few pics of the Hayden 676 transmission cooler installed, I've been having problems with losing 1st gear on take off from 0 mph (after it warms up) and I believe I have "fixed" that issue for now anyway, it stays in 1st gear from start every time now ( I still plan on changing the...

I noticed while driving the other day that the car is not downshifting to 1st. Starting off from a stop in 2nd gear. When its dead cold I believe its actually in 1st until it shifts to 2nd then never gets back to 1st again, and I know my internal tranny cooler is actually warming up my...

Hey guys I'ts nice to be back here, I've long lost my login info I used to be a regular poster a number of years ago, but I have accepted the loss of that account its been years since I've even visited this site. Well, anyway I'm Rick from Orlando, Florida, and this will be my 4th Mark Viii. I...