Recent content by jyarosz

  1. J

    Underdrive pulleys

    Driller I bought a set of pulleys last year that I plan on installing soon.It came with the crank,alt,and water pump pulleys.Since the crank pulley is smaller and the other two are larger you use the same belt.Why do you not recommend using the alt and water pump pulleys?I know they will run a...
  2. J

    removing air injection?

    so what happens if it doesn,t work?
  3. J

    removing air injection?

    My understanding is the air pump only runs for a few minutes when first starting the engine to help the cats heat up in cold weather.I don't drive the car in cold weather.If it wont affect driveability I,ll just leave it off.
  4. J

    removing air injection?

    Did you just unplug the air pump and cap the lines that go back to the cats?
  5. J

    removing air injection?

    My state(Michigan)has no emission testing.I want to install underdrive pulleys and all the air injection stuff is in the way.I have to remove it and don,t really want to put it all back on if its not needed.
  6. J

    removing air injection?

    I have a 96 lsc.I would like to remove all the air injection stuff.Will this give me a check engine light or cause any other problems?
  7. J

    We will all be rich soon!

    I didn,t really buy mine to make money,but I like the idea it should go up in value.I wonder if the mods I'm doing to it will hurt its value.(wheels and tires,exhaust,engine mods for more hp,etc.No body mods.
  8. J

    Splash Guards

    So are they still available?
  9. J

    Splash Guards

    Maybe I missed it somewhere, but who make these splashguards?
  10. J

    Hagerty's list

    Good to know.I keep telling my wife I bought it as an "investment"!
  11. J

    anything going on in southwest florida.

    I,m a Michigan resident with a 96 Mark 8 but I hide out in sunny sw florida for the winter.Anyone know of any Lincoln events down here?
  12. J

    Hub bearing noise, wanna guess which one?

    I have a 96 lsc.I hub swapped the fronts last summer so I could use the wheels I liked.After removing the large nut the factory bearings slid right off.they had 43k miles on them and I would sell them cheap if anyone wanted them.BTW the new mustang hubs I ordered were Timken and WERE NOT made in...
  13. J

    Hub bearing noise, wanna guess which one?

    how long do the factory front hubs usually last?
  14. J

    Trans cooler or High capacity pan

    I plumbed my cooler as a stand alone.It brought my engine temps down.(the engine did run a little hot on hot days) On a 50 degree day my trans runs a little cold(140)but I rarely drive the car when its that cold.
  15. J

    Trans cooler or High capacity pan

    I installed a high capacity pan on my lsc.didn,t make much difference in trans temp.Installed a trans cooler,made a big difference.
Top