Search results

thx guys! Ok so how do i figure out if its the front or rears? i assume its one of the front ones since that's where i'm "feeling"????

Ok so when i first get into my car to drive to work i apply the brakes and the brakes pulse and clunk hard like if the abs system was kicking in but Im just applying the brakes normally in traffic. no abs light or message center error. When i get on the freeway the abs light now turns on and...

I'm looking into getting a cobra intake. My plan is to bypass the EGR with a chip and use the delete plate. When getting a smog check just connect the EGR/tube and make the tube look like it's hooked up behind the firewall. I think that will fool them.

Nice! Can't wait to see it come all together.

I didn't realize you live in Anaheim, I'm in La Habra. Its always good to know of a good tranny shop. I don't need any work done but can you pm me the info, you never know when it could come in handy. U got any pics of your car just in case I see you i'll know to honk. I've seen a red first...

Yup, that's the one I got! Cool, I guess Im ok.

I feel your pain! My car didn't start and after trying and trying I gave up and had it towed to a mechanic. I paid the tow man $50 and he starts to drive off. The mechanic is closing shop as the tow truck heads out. The mechanic looks at it real fast and asks, "you got an alarm?" "Yes," I reply...

All done! I finished the Jmod tonight and I love it! Everything went smooth except for the mess I made and cleaning afterwards :( I followed all the procedures for filling the transmission so I hope it doesn't get damaged. I'm sure it’s fine, I’m just nervous because of my first experience...

Ur car looks evil!

Brittnay has my vote!

I talked to Lonnie and he said I should do both. He said the chip is the computer side of the jmod and the drilling is the mechanical part. He also confirmed that I could use the 98 plate from a crown vic. So, I am going to do both and if the plate is too much I put the stock one back in like J...

Steve, I like the idea of insulation! I may that out since my shield warms up.

It's a "clean built" car, but damn! Was that guy on acid or what? So sad, how many man hours were put into that POS?

A great car and an even greater man! God bless him and his family!

I used that stripped bolt remover tool and it worked like a charm! As far as the bolt that snapped in the block, I used my dremel and a cutting disc to create a grove for a flathead screwdriver to fit into. I got it out like if it was a screw. My first gen baby is up n' running. Thanks for your...

The title says it all?

My water pump went out on my 94 last week so I ordered a new one from Max. I got it yesterday and as I installed it I snapped a bolt into the block. How the F' am I going to get that out? The other three are in so I'm hoping it will hold. I also have a leak coming from the oil adaptor gasket. I...

I polished the stock COP covers and then added a high temp clear coat. I didn't notice a change with the modified MAF but it has to flow better than the stock one. I noticed that the engine has a better growl to it with the box vs just the cone filter.

All done! Here ya go guys! It bolts up to the 2 out of the 3 stock location for the air box bolts. I left the bottom one out because its a little PITA. MAF and 4" adaptor Yes, I gutted the MAF. I think I need a chip for that to work but I figure its less restrictive like this and it looks...

I was bored today so I decided to try to make some kind of ice box. I think it came out pretty good, I just need to paint it, add some rubber and do a couple other things to get it done. What do you guys think? I'll post the final pics when I'm done.