Search results

It is one of the two original keys. However, now that you mention it I did recently change to using this key and fob because battery finally died on the other one. I will try the first key again. Artist fomerly known as "SuperScooter" 97 Blk LSC

I just noticed than when I start the car, the anti-theft light remains light for about one minute. The door ajar switches are fine. Light always used to go off after about three seconds when car started. Alarm still workd fine, blinks when activated etc. Is this prolonged on a symton or...

How do I actually know on my 97 LSC if the IMRC are opening up? Is it a "two barrel" setup like the older Marks? Will it throw a code if they aren't? Cars runs good but just doesn't seem to have that my 94 did. I have done full tune-up, fuel filter, new pump, chip. Am I not getting full...

80K Might go with some NOS later. Would love supercharger but unless I win the lottery!!!! Realistically, will probably keep it where it is now, chip, gears, MAF, K&N. Nothing too much. 97 Blk LSC

I have a basically stock 97 LSC. Thinking of changing the fuel pump for preventative maintenance. Does it help or harm if I go to a bigger pump than stock? If so, where do you recommend buying a bigger pump and what size would you get? Thanks! 97 Blk LSC

Artist fomerly known as "SuperScooter" 97 Blk LSC SOLD THANKS

I lowered my 97 and went with lowrider air struts. So, I have almost new, less than a year old and 3k on them, Arnott Air Struts. I will sell the PAIR (including solenoids) for $150.00 plus shipping. email me: dmfinley@prodigy.net Thanks, David Finley 97 Blk LSC

I bought a 93 one piece shaft to try. It has a bulge in the tube about one foot from the end. Does the bulge end go towards the transmission or the rear end? Thanks for the help.

What exactly are the symtoms? What have you done to brakes/front end? How many miles? Could be numerous items, bushings, ball joints, caliper pins, pads, bad rotor. Jack up the wheel and really give everything a hard shake and tug. It should all be tight. Even sway bar links can give...

What is the part number for the boot only? Artist fomerly known as "SuperScooter" 97 Blk LSC

When changing to 4:10 gears at about what speed does the dreaded driveshaft vibration start to occur? Thanks in advance. Artist fomerly known as "SuperScooter" 97 Blk LSC

Excellent Explanation! Number ONE PROBLEM on vehicle electricals BAD GROUNDS!!!! Clean your grounds, run extragrounds and use dielectric grease to help keep good connections. Artist fomerly known as "SuperScooter" 97 Blk LSC

Does anyone know the Ford Part number for the 3:73 Aluminum Pumkin Assembly that is around $600 I hear? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

There was somethinng mentioned in the past about egine overheating when using 4:10 gears. Does anyone know if this was true and if so, is there a fix? I want to do gears but I need the car to be drivable in the hot Kansas summers. Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

I saw a posting on "another" site that said the Gen 2 Marks use a front wheel sensor instead of speedo gear in tranny. Does anyone know if this is true or not? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

OK, a stupid question but.... Is the factory rear carrier housing on Mark VIII aluminum or cast iron? TBird IRS is cast iron. Are they interchangable? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

OK Gang: I would like to change factory mufflers on my stock 97LSC to something with a little idle rumble. I do NOT want any drone or noise at cruise. I am planning on 4.10 gears soon so cruise rpms should be between 2000 and 2600. I do not plan on any other exhaust changes in the near...