Search results

Selling a set of LSC door moldings. $75 Shipped 704-775-9407

First off, where in Florida are you? Second off, are you sure you really have an evaporator leak, or is the blend door just trashed? Turn the A/C on full blast and feel the lines under the hood. I would potentially also get another opinion on what is wrong with the car. Thirdly, I worked for...

Parts are sold, thanks guys.

Since I am selling my Mark, I have some parts to sell. I am selling a pair of 2004 Cobra exhaust manifolds (03-04 Manifolds have the largest ports and flow the most) I am also selling with this, the fully assembled steering relocation shaft, pictured below. I have included very thing you will...

Amazing build, man!

Looking to see if there is any interest in my car... Considering getting a different car. Car is located in Clermont, Florida. There is NO rust on this car, been in Florida pretty much it's entire life. 175K miles, I would drive it to California right now if I needed to. A/C is ice cold...

J, do you feel like the bigger rear brakes make a noticeable difference in braking? I ask because I just did mine and did it for both eye candy and the added leverage on the brake rotor. Looks amazing as always.

What have you been up to mang, where are you living down here?

Hey Joe, check this out... http://www.lincolnsofdistinction.org/vbulletin/showthread.php?40407-4-25-to-4-50-Bolt-Circle-Change-on-the-Inexpensive

Amazing work, maybe one day I'll be able to afford to do that kind of work to my car. You set the bar pretty high.

Hey guys, I've got an A/C issue and maybe need a little help diagnosing the problem... Here is my problem, last week the A/C quit. I assumed it was just low on refrigerant and gave it a quick check. The pressures are good so, that isn't my problem. Here is a copy of the diagram - Checking...

Pat, I'd like to buy a period.

The jig will come with a 39/64" bit, but if you can get a better quality one, I recommend that. The hard steel on the hubs was really hard on the bit. I actually had started stepping up the sizes between 1/4" and 39/64" so as to make it not as hard to drill the large holes. Just use the jig...

Holy thread necro! That doesn't sound too bad, but may need to get it on a lift.

Or some of the cam followers popped off. If it runs at all, you can't be in that bad of shape.

This didnt take place too long ago, so it's a pretty "young" thread. Thank you though, I always try to share what I have learned.

Where in Florida? I'm in orlando.

No me gusta... blocks the view of the caliper and rotor.

This is pretty awesome, thanks for sharing the progress.

Is it just me... or does that thing kind of say rice?