FS: 03-04 Cobra exhaust manifolds and steering linkage mods kit

9

98mark8lsc

I make stuff
The following items are included:

-03-04 Cobra exhaust manifolds
-Stainless steel u-joint with machined 3/4" DD stub piece
-Stainless 7" 3/4"-36 spline extension piece
-3/4"-36 spline coupler
-One-time-use tube of Blue Loc-tite thread locker for the linkage/coupler set screws

All pieces will be machined as necessary and all fasteners will be assembled with Loc-tite prior to shipping.

The manifolds need some new studs installed (I've already got them ordered), and the nut for the EGR fitting is included, in case you want to make a cap out of it for blocking off the EGR.

This is as close to a full kit as possible. The only other thing needed is to shorten one of the pieces of the shaft that is currently installed on your car. This can easily be done at home with a hacksaw.

All steering linkage pieces are stainless steel where available, with the exception of the coupler piece. I couldn't find a stainless version of that anywhere.

Price is $350 shipped

manifold kit.jpg

manifold kit2.jpg
 
-MARK-VIII-LSC

-MARK-VIII-LSC

New member
How you doing was looking around an seen your ad it might
be a dumb ? But what are the perks of these mods an iam
asking because I am actually interested
 
9

98mark8lsc

I make stuff
-MARK-VIII-LSC said:
How you doing was looking around an seen your ad it might
be a dumb ? But what are the perks of these mods an iam
asking because I am actually interested
Click to expand...
It's a good, cheap way to get better exhaust flow. These manifolds are proven to support power into the 400's. The stock manifolds are fairly restrictive, not to mention the one side with the integral catalytic converter.
 
You must log in or register to reply here.
Top