Asham8 help please

[ChefsteveViii]

So I got around to installing my asham8 today and I am having some issues. I figured to try here for some help before messaging Bela, he takes a little while to get a hold of.
To start of my mark is a 97lsc, I have the second Gen asham8 manual.
Issues I am having is it will not drop at all with the asham8 module. It will however raise from any height. I have to put the 4 jumpers back to the 2-3 postion to get it back to factory height.
Also since the install my drivers door has been screwy and says it's open when it's not.

Anyone have these issues or have pointers?
I have looked over and over to make sure I have everything right and nothing is sticking out at the moment.

Any suggestions or help would be appreciated
Thanks, steve

 

[billcu]

I'd try spraying the door latch with WD40, that is where the door ajar switch is, open and close the door a few times. That usually fixes it. The Asham needs to see that the door is closed to vent.

 

[ChefsteveViii]

I'm definitely gonna do that with some wd40, hopefully that fixes it. Hoping it's a quincedence it started acting up while I was installing the asham8?!
On another note since I'm new to this and I haven't seen anyone post on this subject, how interactive is the asham8? As in how fast does it respond when pushing the buttons, let's say in dropping from normal ride height to slammed?
I bagged my s10 quite some time ago and used 1/2" valves and that was instant, as in hurting your kidneys fast when slamming. I'm assuming this is the complete opposite? Lol

 

[driller]

On another note since I'm new to this and I haven't seen anyone post on this subject, how interactive is the asham8? As in how fast does it respond when pushing the buttons, let's say in dropping from normal ride height to slammed?

The system still inflates and deflates at the same speed as before. There is a bit of a delay after adjusting the Asham8 setting but just a few seconds before it starts to drop or raise.

 

[markup97]

Usually the height will start changing about 30-45 seconds after requesting the new height. As all you are doing is altering sensor signal and the computer has a set signal sample rate, it will only react once the sensor height sample has been read.