Losing water

thegr81

thegr81

New member
Yes it has been burned correctly. And I had Prestone in it until it started wasting that as well. A 15 mile trip to my doctor's office showed no overheating whatsoever but when I stopped and it boiled over. I carry to empty full of water antifreeze containers and a plastic milk gallon with water it took all three. And then I drove home. It has to be the head gasket because the water that bubbled out was nowhere near two and a half gallons. Well thermagasket it is. I'm going to go out on a limb here since I may never have the chance to do it I have my fully polished 98 Cobra intake powder coated blue. Every last nut and bolt aftermarket, the gaskets, everything needed for the Cobra intake swap. I also have the Terminator manifolds with the steering shaft, the knuckle, and a little piece of D&D for relocating the shaft I would entertain offersjust
 
thegr81

thegr81

New member
Well it's definitely the head gasket. Time for a dose of thermagasket that I swear by as long as you catch it before you lunch your motor. Worked in my first car until I wrecked it. That I sold before I got this one. Let's hope that it continues to be the solution as the car still runs drives accelerates flawlessly and is in perfect condition. I still get offers to sell it but at this point unless I come into a lot of money this is going to be the one to the end. And even if I come into a lot of money it's still going to be the one of the end just a lot nicer. That's how much I love my Lincoln
 
You must log in or register to reply here.
Top