Search results

Well while I was working on the mark trying to figure out my torq converter lock up issue. i was adding tranny fluid and the car dies and wont restart. So I check the fuse's and the ecm or #8 is blown. So I put in a new one and blows. So I break out the trusty fluke meter and it Reads 8 ohm...

Here's a fun one. So I'm driving home one night down the highway, and I notice the car is handling a little funny. then low and behold I get a check air ride message. So I get to the 7-11 get out and all most fall over. the car was completly on the ground. so I cycle the key and the compress...

Well my t/c is still locking up early, I put a new tcc soliniod in it. still locks up as soon as goes in second. and it only seems to unlock when I manually put into first. After I drive it for a little it behaves better, or its just slipping. It wont unlock when I hit the brakes. Is there a...

I found a new problem with the mark. sometimes when accelarate hard around 2800 rpm's the motor seems to cut fuel or spark, then when it drops to about 2400 rpm's it comes back on with no more problem's. I think it might be a fuel pick up problem. I do have about a 1/4 tank of fuel in...

I found me a running motor, transmission and rear diff for 250bucks out of a 94 mkviii. So while I'm staring at the stuff in corner of my garage. I could not decide what to with it. I'm thinking an eaton m90(because I have one on hand.) or maybe nos for the same reason. I have 4.10's ordered all...

I just rebuilt my tranmission with a new torque converter. the torque locks up very earier and does not unlock untill the car is about to stall. not sure on what is going on. any idea's

Well I'm putting in a new torque converter with a 2500 stall. Do i need fill it with fluid first and how much. I also put in all the goodies when I rebuilt it. I help it works its my first time.

Well my 3rd gear problem is also 4th gear problem. So I decided to drop the pan and check it out. I check the the shift soliniods they are good. there appears to be a lot junk in there. So I'm going to rebuild it. I do have a question though do I have to drop the gas tank to get the drive...

My tranny seems not to be going into 3rd. When it should be going into 3rd the engine revs freely. if I bring the rpm's up to about 4500 it catch's again and is fine. Not sure if it catchs 3rd or goes in to 4th. and Idea's On another note, when I hit the breaks to slow to a stop it drops to...

I found the bracket got it all back together and the car will not stop. the brakes wont even hold in gear at idle. I put a new master cylinder, cailpers and rotors all the around. Bled the brakes twice and still no better, any Ideas? thanks

For a 1994 driver's side i cant find one any where. Haven been to the junk yards yet, doing that tomorrow. Does any one know what my options are or what else has the same bracket. thanks for any help buchshot

I just bought it yesterday just wanted to say hi, and I need parts.