Search results

94 Mark VIII, 98,300 miles, car is from SE Virginia, now central NC for 1 year. Looks like I have some excess play in my rack, about 3/4" in/out when shaking the front rim at 3 and 9 o clock with front end of the ground and steering wheel locked. The steering wheel moves in unison with the rack...

98 LSC A few days ago the blower stopped working completely. With car running and heat on 90 I started by jiggling the harness from the relay to the motor, but got nothing. I checked voltage on the two blades coming off the relay and got nothing. I checked power in the plastic connector to the...

1994 Mark VIII, 92k with my original module, I was flashing airbag error code 35 " Passenger side AirBag circuit Low resistance or shorted." ----- put in a different airbag module from a '94 mark VIII (not wrecked but not known to be good) and I immediately got code 51 -Air bag diagnostic...

Earlier today I got in my 94 and the compressor didn't come on (unusual) I drove about 3 miles and while on the highway got the ''check air ride message'' and cleared it. I got off the highway at my exit about another mile down the road, drove about another mile to the grocery store and noticed...

it looks like I'll once again be diving into new territory, removing the intake manifold for the purpose of cleaning the IMRCs, mostly the drv side --- I have a shop manual for a 96, other than the cop's what differences will I run in to? Any and all advice/photos is greatly appreciated. I found...

A little while back I sent my xcal 2 to a tuner for unlock and custom tune for my 98 LSC, 126k miles, jmodded- no other mods I noticed under wot it was running poorly with the tune, so someone suggested I evaluate fuel pressure with and without the custom tune ---- vid 1: wot with custom tune...

Need transmission help. 94 mark VIII, 91k miles After finishing Jmod on the 94 it's slow to initiate Reverse (engages at about 1700-2000 rpms) then shudders while driving in reverse. I drilled all the holes except the one to speed up R (hole #10 at bottom right) It is a little slow to engage...

I'm swapping the interior from tan to black in my 94 mark. Does anyone know which steering wheels from FLM will fit? Mustangs 94-04? I know most or all 89-97 Tbird/Cougars will. Not looking to break the bank. <$100 Thanks!

I picked up a '94 Mark about 3 weeks ago after totaling my '96 I owned and worked on for 12+ years, oh well. The new car has 88k miles, about 15k in the last ten years, lots of sitting recently with start ups 2-3x/month. Orig. front end suspension including air ride. No significant repairs to...

96 base --- a few days ago my dash ABS light came on and stayed on- it did not flash. The trac control button under the eatc is fixed OFF- pressing it does nothing. I jumped the ground and trigger pins on the red ABS test harness behind the passenger head light,then turned the key to RUN. The...

Yesterday I filled up my truck with parts from a BoB 95 LSC, mostly interior: seats, rear sail panels, center console, shifter, eatc and radio bezzle, under dash and kick panels. The plan is to swap out the ivory interior in one of my 96's. While unloading I just realized the donor car was...

the last experience I had at my local stealer resulted in my first trans leak. I HATE going there and hoped I'd never need to again. Since a friends' recent Mark VIII car-fire I figured I'd take a chance. How much damage could they do with a cruise control wiring recall mod (51FOZ17)? The job...

as is usually the case, bank 1 pod is leaking; I have a good unit to replace it with -removed the bolts hold the pod to the housing assembly last night; but can't see where to disconnect the elec cable for the pod; do I have to go underneath the engine and find/disconnect it there? --

the mech who has my seized knuckle and damaged half shaft cannot press it out. So I need one. 89-97 t-bird/cougar w/ discs....or 93-98 mark viii. I'd really like to trade some of my spare Mark parts and I'll pay shipping, or I can pay cash out right.

Does anyone know which years are compatible with my 96 for ABS module, pump, sensors?

I am doing a hub swap and obtained a pair of rear knuckles with the hub already modded for 4.5''. Right now I can't figure out how to get one of the torx bolts clear from the bottom of the axle to pull out the knuckle...what am I not seeing or doing? thanx, Dan 96 Mark base model --- driver's...