What did you do to your Town Car today?

casper

casper

New member
Finally got around to my ABS problem on mine. Turns out, the sensor on the front right was rusted, and couldn't "see" the star wheel. I ordered one for both sides.

While in there, I noticed the upper ball joints need replaced, so that's next
 
Lvnmarks

Lvnmarks

quandoomniflunkusmoritati
Try takeing a file to the teeth on that ring, might help if the sennsor can see solid metal.


Drove to work today still pissed off that it wont accelerate corectly....:(
 
J

jackofroses

New member
so today , i performed some exploratory on the 93.

found the rattle ....... heat shield on one of the resonators....

the starter issue was an obvious cure........we got a new starter , but we never did get around to tightening the bolts....oops .......that wont be an issue again.

lookie lookie new front brake pads too..... too bad i lost that confounded line-up pin!! oh, well one outta two oughtta be plenty right? RIGHT!?! i'm scairt , aint you boys scairt?

so i noticed a green droplet under the engine , so i drained the coolant, looked ok so did all the connections.....could just be from sitting , i guess.....likely a water pump....we'll see what happens.
power steering sludge down there too , but the res was full of clean fluid ..... i added a bit of additive.

tie rods ends and ball joints look ok , sway bar links , not-so-much.

so far 99% of this cars issues were the laziness of the previous owner.

i'm sure glad i investitgated , those brake pins could have been ugly
 
T

TCinPhilly

New member
Brand new state inspection, new Quaker State synthetic oil, wash and wax, full tank of gas.

Carlisle, here we come!
 
You must log in or register to reply here.
Top