Recent content by ghost2

FOR SALE: Good HID bulb for 96,97 or 98. Wires and connector in tact ready to plug and play. Comes with the plastic cover also. Make me a reasonable offer.

Where on earth do I get a master cylinder reservoir? 1996 LSC

1996 LSC . I have an oil leak somewhere. My mechanic thinks it might be a cam shaft seal. Is that a monster job? Or....Does the leak sealer additive solve the problem?:frown-blue:

I tried the search and had no luck so here ya go. 1996 LSC the first section of tail lights on the left side of the trunk portion of the array is out. Is this a bulb or some LED array with a ballast etc. Thanks for the help.

I have a 96 LSC and the front seat skins are bad. I have located some good Gen 2 skins. Can I swap skins?

I need a Black seat skin for a 1996 LSC. Also need a center cap for one wheel.

I need a black drivers seat cover for a 1996 LSC

This is a little strange. This morning , just after a cold start [not real cold I'm in Florida] the check engine light starts blinking and the car seems to be running "jerky". 45 seconds later the the light goes out and the car runs fine???? Your suggestions are very welcome.

Can i use a gen 2 HID bulb in a Gen 1 [LSC] HID socket. ie are they the same bulb?

My serpentine belt tensioner pulley is whining. is this a typical problem on our cars. [96 LSC] Is this a difficult part to change? I see that Advance carries the Dayco pulley. I'm assuming that Dayco is a reasonably good product?

1996 LSC looking at the engine on the left hand side I see a small yellowish box that says Air Ride/EVO, is this a plug in test module of some type?

After you remove the PS pulley, how do you reinstall the pulley on the new pump?

How much PS fluid [Mercon 5] is required to completely flush the rack?

I searched and came up with zip so I'll ask. How do you replace the brake light bulb [pass side] on a 1996 Mark?

Does the 96 Conti have the same IMRC set up as the Mark Viii for 96?