Search results

FOR SALE: Good HID bulb for 96,97 or 98. Wires and connector in tact ready to plug and play. Comes with the plastic cover also. Make me a reasonable offer.

Where on earth do I get a master cylinder reservoir? 1996 LSC

1996 LSC . I have an oil leak somewhere. My mechanic thinks it might be a cam shaft seal. Is that a monster job? Or....Does the leak sealer additive solve the problem?:frown-blue:

I tried the search and had no luck so here ya go. 1996 LSC the first section of tail lights on the left side of the trunk portion of the array is out. Is this a bulb or some LED array with a ballast etc. Thanks for the help.

I have a 96 LSC and the front seat skins are bad. I have located some good Gen 2 skins. Can I swap skins?

I need a Black seat skin for a 1996 LSC. Also need a center cap for one wheel.

I need a black drivers seat cover for a 1996 LSC

This is a little strange. This morning , just after a cold start [not real cold I'm in Florida] the check engine light starts blinking and the car seems to be running "jerky". 45 seconds later the the light goes out and the car runs fine???? Your suggestions are very welcome.

Can i use a gen 2 HID bulb in a Gen 1 [LSC] HID socket. ie are they the same bulb?

My serpentine belt tensioner pulley is whining. is this a typical problem on our cars. [96 LSC] Is this a difficult part to change? I see that Advance carries the Dayco pulley. I'm assuming that Dayco is a reasonably good product?

1996 LSC looking at the engine on the left hand side I see a small yellowish box that says Air Ride/EVO, is this a plug in test module of some type?

After you remove the PS pulley, how do you reinstall the pulley on the new pump?

How much PS fluid [Mercon 5] is required to completely flush the rack?

I searched and came up with zip so I'll ask. How do you replace the brake light bulb [pass side] on a 1996 Mark?

Does the 96 Conti have the same IMRC set up as the Mark Viii for 96?

:eek: I was in the junk yard the other day searching for some bits and pieces and found a 1996 Lin. Continental. Lifted the hood and "wow" it was our 4.6L 32 valve engine [mounted transversely]. OK, my Mark is a 96 LSC and I'm looking for some back up IMRC actuators [the high bred one year only...

I was under the hood today looking for little things to attend to and I hear this sucking sound. I hate vacuum leaks so I went on a witch hunt and found a mother of a vacuum leak. It's a 90 degree rubber hose that comes off of the PCV and down to the valve cover. It has a large hole in it...

This little "clinking" noise has driven me mad for 2 months. While driving over slightly rough surfaces I can hear a metallic clinking sound [like cheap tin hitting metal] it sounded like it was coming from the dashboard area so that area is what got the attention. However yesterday with my son...

While driving at moderate/mild acceleration I notice a bit of "jerkiness" at or around 40mph. If I add pedal it's gone or if I back off it's gone or if I cross that number at more aggressive throttle it never shows up. Feels like empty space? This is kind of picky but somehow it doesn't seem right.

Has anyone had experience with the General Altimax HP 98V tires on a Mark Viii. http://www.tirerack.com/tires/tires.jsp?tireMake=General&tireModel=Altimax+HP&partnum=26VR6AMAXHP&vehicleSearch=true&fromCompare1=yes&autoMake=Lincoln&autoYear=1996&autoModel=Mark VIII&autoModClar= I compared the...