Search results

Anybody got any ideas on how to prime the oiling system on a DOHC motor. The only way I can think of is pullin the spark plugs and crankin the engine. I'm not sure that the starter will crank fast enough to build any pressure. Lookin for some ideas. Just pull the distributor and use a drill on...

Sorry guys Im gonna ask another SC question because im hopin the Mark has the same set up. Has anyone replaced the pressure line that goes from the pump to the rack. I have some stainless steel braided line I would like to put in but the factory line runs from the pump and has a loop that...

I know this is the wrong site for this but you never know who is lookin. I have pulled the motor out of my 94 SC and am installing my cobra motor. I want to sell the complete powertrain as one. If this does not go well I may part it out but probably not. This would include the engine, trans...

Well guys its time to pull the trigger. This weekend I will begin my install of the M90 supercharged cobra motor in my 94 Thunderbird SC. I know there are Thunderbird related sites that this would fit better in but I enjoy this site way better than those sights. So you guys are gonna have to...

I am looking for a 97-98 Mark VIII power steering pump. I really dont need the whole thing but what i need is the EVO sensor and the fitting that threads into the pump where the High Pressure Line goes. I understand if someone does not want to disassemble a pump for these parts so let me know...

Just seein if there is any interest here before i Ebay these. I have an overhead dvd player and front stack trim piece with heater controls and all switches. I also have a very nice set of complete headlights and foglights. I can get pics if anyone needs them. Dvd player- 200 + shipping OBO...

Lookin to put 36lb injectors in my cobra motor project. Let me know what you got. Thanks Lee

I found this in some of my stuff. Do you guys think this would give me any kind of benefit ? If not i may just sell it. Let me know what you think guys. Thanks Lee P.S. This is gonna be going on a m90 supercharged 96 cobra motor.

Just as the title says I am lookin for a throttle and cruise cable out of a 97-98 Lincoln Mark VIII. Also if anyone knows anyone with a CCRM from a 96-97 Cobra. Thanks Lee 734-637-9267

Guys, I know this is not Lincoln related but all you guys have been a huge help so far and i am not gettin anywhere with any other forums. I am trying to locate a wiring diagram for my 94 thunderbird. I need to pinout the 2 connectors that connect to the dash harness on the PCM harness. I...

Guys im hopin someone here can help me. I am tryin to figure out how to wire up the IMRC to a RPM switch. This cobra motor has the electronic IMRC control not the vaccuum ones. There are 4 wires on the connector and i do not have a wiring diagram for this. Hopefully someone here has the...

Guys i am tryin to get paarts together for my Cobra motor swap. The cobra motor has red top 30 lb injectors. The stock 89-93 super coupes run 30 lb injectors. Can i use a MAF off a stock SC ? Obviously there may be some repinning or connector swapping, but from a calibration stand point will...

Hey guys just wanna introduce myself. My name is Lee. I currently own a 94 SC that is gonna get a 96 Cobra M90 supercharged T45 transplant. Vehicles I've owned- 2-86 5.0 fox birds 2-86 turbo coupes 2-89 Mustang 5.0 1- 89 SC 5-speed RIP always be my favorite car(if the back seat could talk...

I am looking for a set of mark VIII manifolds or used headers. If the converter is cut off the manifold that is fine. I am new here but i have been a member for a while at SCCOA and always pay promptly. Thank you Lee lbilli10@ford.com