Newer focus wheels interchange?

D

Derrick61

Registered
I know the lug pattern is the same, but does anyone know if the 20teens focus wheels fit the hubs on our Mark Viii's?
They have some nice factory wheels on some of them and can be bought for low $$$$
 
The Mark VIII hub diameter is 2.79", so you want wheels with a 2.80" hub bore. Any bigger and you will need hub rings.

Wheel offset is also a key issue.
 
Hub-centric rings don't carry any load and are not required for a secure installation. However they help line things up to minimize the chance of higher speed vibrations.
 
driller said:
The Mark VIII hub diameter is 2.79", so you want wheels with a 2.80" hub bore. Any bigger and you will need hub rings.

Wheel offset is also a key issue.
Click to expand...

Is that accurate? The research I've done indicates the hubs on the Mark VIII are 63.4mm which equates to 2.49".

Asking because I'm looking at doing a Fusion wheel swap.
 
Prospect62 said:
Is that accurate? The research I've done indicates the hubs on the Mark VIII are 63.4mm which equates to 2.49".

Asking because I'm looking at doing a Fusion wheel swap.
Click to expand...

You know, I think you may be right! :oops:

I have stock cars, hub swapped cars, stock wheels, Mustang wheels, drag wheels, custom wheels... it gets confusing at times! LOL :ROFLMAO:

But I do know according to my measurement notes I have on my phone for my '96 (with stock hubs and custom 18" wheels), I have bought hub rings that were 2.5" ID x 71mm OD and the hubs 'measured' 2.5".

Stock offset is +39mm.
 
You must log in or register to reply here.
Back
Top