Tremec 6 speed install in work. Has anyone done this before. 98 mark. I'm using the clutch pedal assy. from a supercoupe. having the drive shaft mfg. we used the existing trans support. Everything seems fine so far. Shifter location is falling right in the sweet spot. I'll have pics. later and note any severe problems. We may have a PCM harness made and move the PCM behind the rear seat. That will be much less work than spliceing all of the wireing. Most clearance problems have been minor so far. I also plan on building a forged engine and adding Twin turbos to the shark. More to follow.
Sounds sweet! I still haven't found your LvC pics, though...
OK, thanks. So the shifter really just happened to lie exactly where it needs to be?
That is most excellent. Was there much price difference between a TR6060 and a T-56, before any customization comes into the picture? I can imagine what a .50 6th gear will do both for cruising MPG plus potential top speed/acceleration when mated to 3.73 or 4.10 gears!!
Actualy the 6060 is the less expensive. Plus the shifter location eliminates a lot of pain. We are getting the tuner from SCT so should have it setup and on the road very soon now.