Blend door in conti like Mark 8??
- Thread starter avm3
- Start date
J.
Thanks a lot for your offer to post more info on the 02 Conti blend door replacement. I'd very much like to see a picture and/or some procedure to replace it. There is a quite thorough one for the Mark 8 that I followed (about 50 steps to get to it!), without which I would have been lost. Do you go at the Conti one from under the hood? I think that the quoted labor for the Mark 8 version is more on the order of 6-7 hours, so maybe the Conti one isn't quite as much of a bear.
Anyway, I look forward to you posting some details!
Thanks!
/Art
Thanks a lot for your offer to post more info on the 02 Conti blend door replacement. I'd very much like to see a picture and/or some procedure to replace it. There is a quite thorough one for the Mark 8 that I followed (about 50 steps to get to it!), without which I would have been lost. Do you go at the Conti one from under the hood? I think that the quoted labor for the Mark 8 version is more on the order of 6-7 hours, so maybe the Conti one isn't quite as much of a bear.
Anyway, I look forward to you posting some details!
Thanks!
/Art
Ok, looking over the removal, it sounds SUPER easy. I think its under the dash on the passenger side. Look.........
Electronic Blend Door Actuator
REMOVAL
Remove the instrument panel insulator.
1 Remove the pushpins.
2 Disconnect the courtesy light and remove the instrument panel insulator.
Remove the floor console.
Remove the screws and remove the cover.
Remove the A/C electronic door actuator motor.
Disconnect the connector.
Remove the screws and remove the A/C electronic door actuator motor.
INSTALLATION
To install, reverse the removal procedure. (LOL!)
Don't know why it would take someone 3.4 hours to do it, but hey, you never know.
Electronic Blend Door Actuator
REMOVAL
Remove the instrument panel insulator.
1 Remove the pushpins.
2 Disconnect the courtesy light and remove the instrument panel insulator.
Remove the floor console.
Remove the screws and remove the cover.
Remove the A/C electronic door actuator motor.
Disconnect the connector.
Remove the screws and remove the A/C electronic door actuator motor.
INSTALLATION
To install, reverse the removal procedure. (LOL!)
Don't know why it would take someone 3.4 hours to do it, but hey, you never know.
J,
Thanks a lot for posting the pics and instructions It looks deceptively simple, after the PITA of the Mark 8. Almost sounds like I can even figure out if it's broken before I replace it! The Mark is undrivable once you get into the repair.
Will look into this as soon as I can pry the car away from my wife for a few hours.
thanks again!
//Art
Thanks a lot for posting the pics and instructions It looks deceptively simple, after the PITA of the Mark 8. Almost sounds like I can even figure out if it's broken before I replace it! The Mark is undrivable once you get into the repair.
Will look into this as soon as I can pry the car away from my wife for a few hours.
thanks again!
//Art