Mad1stGen
Registered
My schedule finally cleared up enough that I could start working on this small side project. :smile-purple:
The main idea is to use 97-98 Mark VIII PCM and associated control modules to "tame" this beast.
When one gets serious with modifications, it becomes very clear very fast that pre-96 PCM controls are very limited, and an upgrade is required.
Most shops will tell you that you have to go to a standalone engine control system like FAST, etc ..., but the cost, and lack of transmission controls leaves a lot to be desired.
So, let's use the technology that is widely available, although scary to some. :eek-large:
Here's the engine bay before any modifications.
The main idea is to use 97-98 Mark VIII PCM and associated control modules to "tame" this beast.
When one gets serious with modifications, it becomes very clear very fast that pre-96 PCM controls are very limited, and an upgrade is required.
Most shops will tell you that you have to go to a standalone engine control system like FAST, etc ..., but the cost, and lack of transmission controls leaves a lot to be desired.
So, let's use the technology that is widely available, although scary to some. :eek-large:
Here's the engine bay before any modifications.