Note #4 for jmod instructions, create slot .100 with razor

J

jruppert

Registered
Can anyone explain this note a little more in detail? I am confused as to where this slot is suppose to be. Thanks
 
jruppert said:
Can anyone explain this note a little more in detail? I am confused as to where this slot is suppose to be. Thanks
Click to expand...

I think that slot goes in the gasket.

"NOTE #4: There is a very small gasket slot in this location (arrow points to it). This is slot number 1 on the drill specification chart. Open this slot to the correct size based on the chart and your application. If you are opening the holes to the less than 300 HP range, you DO NOT have to change this slot."
 
Last edited:
You must log in or register to reply here.
Back
Top