Search results

I just noticed than when I start the car, the anti-theft light remains light for about one minute. The door ajar switches are fine. Light always used to go off after about three seconds when car started. Alarm still workd fine, blinks when activated etc. Is this prolonged on a symton or...

How do I actually know on my 97 LSC if the IMRC are opening up? Is it a "two barrel" setup like the older Marks? Will it throw a code if they aren't? Cars runs good but just doesn't seem to have that my 94 did. I have done full tune-up, fuel filter, new pump, chip. Am I not getting full...

I have a basically stock 97 LSC. Thinking of changing the fuel pump for preventative maintenance. Does it help or harm if I go to a bigger pump than stock? If so, where do you recommend buying a bigger pump and what size would you get? Thanks! 97 Blk LSC

I lowered my 97 and went with lowrider air struts. So, I have almost new, less than a year old and 3k on them, Arnott Air Struts. I will sell the PAIR (including solenoids) for $150.00 plus shipping. email me: dmfinley@prodigy.net Thanks, David Finley 97 Blk LSC

I bought a 93 one piece shaft to try. It has a bulge in the tube about one foot from the end. Does the bulge end go towards the transmission or the rear end? Thanks for the help.

When changing to 4:10 gears at about what speed does the dreaded driveshaft vibration start to occur? Thanks in advance. Artist fomerly known as "SuperScooter" 97 Blk LSC

Does anyone know the Ford Part number for the 3:73 Aluminum Pumkin Assembly that is around $600 I hear? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

There was somethinng mentioned in the past about egine overheating when using 4:10 gears. Does anyone know if this was true and if so, is there a fix? I want to do gears but I need the car to be drivable in the hot Kansas summers. Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

I saw a posting on "another" site that said the Gen 2 Marks use a front wheel sensor instead of speedo gear in tranny. Does anyone know if this is true or not? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

OK, a stupid question but.... Is the factory rear carrier housing on Mark VIII aluminum or cast iron? TBird IRS is cast iron. Are they interchangable? Thanks, Artist fomerly known as "SuperScooter" 97 Blk LSC

OK Gang: I would like to change factory mufflers on my stock 97LSC to something with a little idle rumble. I do NOT want any drone or noise at cruise. I am planning on 4.10 gears soon so cruise rpms should be between 2000 and 2600. I do not plan on any other exhaust changes in the near...