Search results

Took my 98 LSC to the track today. Conditions were in the 70's-80's, the DA started off at 1300-1400ft and went down to 750-800 feet by the time we were done. The usual Sonoma Raceway headwind was in effect as well. I was in full street trim on my heavy 19 inch wheels with street tires, the cut...

Got a good launch, managed an impressive 2.15 60 foot time and the car went 14.7 at 94.5mph. It's a bone stock 93 Mark VIII with 50,000 miles on it. Technique was flash the converter and leave it in drive, no burnout.... 42psi in the front tires, 30psi in the rear. The car also had little cool...

Is there a way you can reuse the stock gen 1 IMRC controller from a 94 Mark VIII to run the 98 plastic IMRC's with a Cobra intake swap?

What stage are you guys using? Should I go straight to stage 5 and reprogram my line pressure to mild settings?

So I decided it's time to get serious and get the Cobra intake manifold and the MMR IMRC deletes along with an Aeromotive FPR. My question is will the Aeromotive FPR fit on the Mark VIII rail with the Cobra intake installed?

100 shot, weak 2.1 60 foot time, super conservative nitrous tune with only 20 degrees of timing and 10% richer on top of the base nitrous tune. Conditions were humid and windy. Beat a new V10 M5 who ran a 13.5 at 111mph with a 2.4 60 foot time. 12's coming up after I get this thing on a dyno...

Can I use the gen 2 IMRC's and controller on the cobra intake manifold? I know the IMRC's can be used for sure but does the gen 2 controller work fine with the cobra intake?

So I moved the nozzle down on the intake tube and was set for the track. Too bad I didn't realize how low I was on nitrous. It would not get over 800psi so I think it was more like a 75-80 shot at the wheels, the car didn't hook it did a terrible 2.25 60 foot time and I sprayed as soon as I hit...

Very frustrating night at the track. The first run I was so nervous I hit the bottle heater switch instead of the nitrous and it ran a 14.3 on motor on the nitrous tune. Second run was even worse on the nitrous. I hit it in 1st gear right after 3000rpm and it bogged down HARD when it hit. I...

OK well I got my HSW wet kit in with a 15lb bottle, ready to see what this bone stock 4.6 DOHC is really capable of... I know some of you guys have run nitrous on a Mark VIII, any pics of your bottle mounted, pics of the nitrous/purge switches installed etc?

Ran a new best in less than perfect conditions... 2.05/14.02/97.4mph, also broke into the 8 second 1/8th mile on that run for the first time...

http://www.searspoint.com/multimedia/news/545680.html

So I was driving today and noticed the temp gauge was running hot. It almost got to the red, I pulled over and checked to see if the fan was coming on. It was but it ran so hot coolant came out the overflow bottle. I looked to see if coolant was leaking from the water pump, it wasn't. The...

Check this out... http://www.team-integra.net/forum/display_topic_threads.asp?ForumID=15&TopicID=252077

Apparently the 98 PCM reads off a different spark table (MBT) and it has a limit on what the total peak timing can be... for me that limit is 28 degrees at WOT. I'm trying to get around this and have started to work with a Sniper tech to fix this. Is anyone running more timing than this on their...

How long did it take you guys to get 1000 posts on here?

Is anyone running a speedo gear on a gen 2 with gears? My car's speedo MPH is right on point but it will hit the rev limiter once in a while going WOT in drive on the 1-2 shift?

I was doing some datalogging today and my car hit the rev limiter on the 1-2 shift. Right after that I got a CEL P0320. I tried to clear it with Sniper but it keeps coming back. Cam Position Sensor or Crank Position Sensor? I found this info online: P0320 - Ignition Engine Speed Input Circuit...

I have a few questions about installing a 97 Cobra intake manifold on my 98 LSC. Can I use my following stock parts: IMRC controller and plastic IMRC's fuel rails throttle body cable

I need a new right rear caliper... do I need to get oem or can I get something like the A-1 Cardonne for cheaper with the same performance?