Search results

Hi everyone, I have a set of two 02 sensors for just the rear on cars that use 4 sensors. Connectors on them are blue. They are Ford sensors. They came in a set of 4, with two that had green connectors. I used the green ones for my front o2's but have a 93 so don't need the other two. I'll...

Hey guys, Does anybody have the dimensions handy for boxes they have put under the package tray. I am thinking of removing the rack under there and fitting in a box which would vent through the package tray into the passenger area. This was the setup a shop was telling me they would do for...

Hey guys, I am getting ready to pull my trans and wanted to just clear up a few questions. I have read some posts that make it seem pretty straightforward. One question is, do you have to do anything special on the dipstick tube? Is it just a matter of removing the bolt off of the back of...

Has anyone added a module for one-touch window down on their passenger side? I want to be able to roll it down with one touch from the driver's switch. I am guessing I just need to wire in a module for that switch. But wondered if anyone has done this and could throw in tips on the wiring...

Is there a difference between the 2wd and the 4wd transmissions that are available? Someone said you are supposed to use the 2wd version, but I never saw the reason why anywhere.

Hey guys, My car (1993) has 175k, and the tranny is on its way out I think. Starting out it will rev past where it used to shift into 2nd, and you have to let off the gas completely to let it shift. I am thinking it is probably the one way clutch from the reading I have been doing. The Jerry...

My 93 with 175k just recently started to do this. As I am starting off the line, it revs up and doesn't want to engage the next gear. It will keep revving, and I have to let off the gas to get it to shift. I replaced the 1-2 accumulator last summer, along with Mercon V. I am wondering if...

Here's some pics of my highway rocker. They were taken on my trip in May to Colorado. Marks can climb mountains and go down bad dirt roads. You just have to be ultra careful... http://home.earthlink.net/~craigbarchers/AttheRestStop.jpg...

I took a trip of about 1500 miles from Texas, through New Mexico, Colorado and Kansas. Turned 171,000 miles and my Mark ate it all up with no complaints, MPG was 24.9. I was getting a check engine light previous to leaving, and pulled the codes. I got a 579 which has to do with Manifold...

I have some questions about how I should get gears installed. I bought a trac-loc and a set of Ford Racing 4.10's that were slightly used. I've run into a problem, discovering that shops don't want to install parts I supply and especially if they are used. I am thinking of trying to do this...

Hey guys, I was driving home the other night, and got on it after a turn. The car revved up to 6k where it usually shifts if I am driving hard, but this time it didn't and the revs went right into the red area, almost to 7000. I let off quick and it didn't seem to affect anything. I have...

Hey guys, Here are some recent pics of my Alpine installed. I did clean up the stereo surround bezel of the easily scratched coating, sanded, and resprayed with Krylon black "Semi-Flat" spraypaint. This matches almost perfectly with the color and gloss level of the bezel surrounding the AC...

Do you guys know if there would be any difference between using something like this http://www.autotransinc.com/shudfix.htm versus a chip from geno or dennis? I am thinking a chip would control lockup and a variety of other stuff, but I saw a post by a guy on Modular Technical Forum that...

This dude has a homemade PC setup involving some rather diverse elements. Anybody into fabrication, and electronics in the car should appreciate. www.smanders.com

Are there any good freeware box design programs that you can plug the parameters of your speaker into? I'm just curious, I think it would be cool to be able to plug in like the height and width of a box design and then let the program give you the depth you will need, for the speakers you are...

Hey y'all I was driving yesterday, and got ce light and some codes. The car was stumbling really bad at around 1000 rpms, and light throttle. It seems fuel related. The fuel filter is about 1 year old. I pulled the codes by grounding the self-test lead, and the codes I got were: 539...

Hey guys, I just installed my Alpine a few days ago. I'm lovin' it. Awesome looking unit, and many cool features. For what I found it on an awesome auction site, it is a very competitive package. I am still exploring all the options and stuff, but so far, really enjoy the wma/mp3 cd...

Hey guys, My eclipse was stolen, so I am looking at these two Alpines. I am leaning toward the 9815 because it is black and has more of the features I want. Does anyone know what the black out display feature does? Also, the 9815 has v-drive, a high power amp, which they say you need to hook...

Does anybody know of a program like Easy CD Creator for XP that allows exact cd duplication? When MS switched to XP they pretty much forced you to buy a new $70 copy of easy cd creator or make do with windows media player which doesn't allow you to make an exact copy. I am just wondering...

Hey all, Here's the new profile pic http://home.earthlink.net/~craigbarchers/PIMPY3.jpg